The rear half of the sphere is pictured from its inside face and shows the bell-mouthed shaped oil baffle soldered in place.  It is designed to keep oil in the sphere and from draining down the torque tube.  It was fitted to the sphere of the late British Silver Ghosts and to the PI.

Section 1 - Disconnecting Torque Tube
Section 2 - Removing the Front Section of the Torque Tube
Section 3 - The Mathematics of an Overdrive
Section 4 - Checking Universal Joint and Bearnings
Section 5 - Installing Overdrive in Drive Line
Section 6 - Overdrive Lubrication
Section 7 - Connecting Speedometer and Electric Controls
Section 8 - Hooking up the Electronic Control Box
Section 9 - Hooking up Speedometer and Calibrating Output
Section 10 - The Overdrive in Operation
Section 11 - Overdrive Service
Section 12 - Crusing in Overdrive
Endnotes - Endnote
Table 1 - Silver Ghost Rear Axle Gear Ratios Comparisons
Table 2 - Engine Revolutions per Tire Turn
Table 3 - Overdrive Speedometer Gears for the Silver Ghost